If you installed the Bosch Dual Bevel GCM12SD axial Glide seen, you know immediately that there is something different about it. If you are familiar with all the saws, you'll know what I mean.
No Rails for greater accuracy and space savings
There are binary. What are rails? It was the industry's attempts to set a precedent with greater ability to miter cut. Wearing basically what they did, cutting-off and the motorBladeSystem component and mount it on a series of tracks that travel to the saw back and forth, while allowing rotation up and down. They worked well, but left much to be desired in the accuracy department. Just the design of them was not strong enough to steady the saw along the entire length of the cut. Surely they could all be at the very beginning of life has seen, but over time would thus increase to vibration over time.
Bosch engineers have developed what they call the axialGlide system, a series of articulated arms to achieve the same purpose as the rails, but they are beefier and smooth running. With traces of sawdust and dirt (particularly sticky pitch pine) may contaminate the powder flowing so that they are difficult and the introduction of inaccuracies in the cut. The articulated arms about this new visa, virtually eliminating its 12 ball bearings with this problem. There is no way for the construction of dust and dirt and getting to disturb the flow andAccuracy.
Not only is the system for axial sliding unparalleled softness and durability, but also saves a huge amount of space. You see, the old railway system which had the presence of space because they had seen more space to allow the return of the saw for rails to work. With the system of axial sliding, hinged arms to fold properly and is flush with the back of the saw blade so to save up to 12 "of real estate than standard railsSystem other sliding miter saws. This means that you can set this saw directly onto the wall in your shop or site. And let me tell you, if you have a number of trades on site have the same space is a premium.
Controls increased cutting capacity and Up Front
GCM12SD The patented design axial sliding increases the ability of hand-cut to 14 "horizontal, 6.5" vertically against the wall (for cutting molding large base) and 6.5 "crown moldingPosition "nested" (45 degrees spring). The range of gunfire GCM12SD is 52 degrees to 60 degrees left and right with 10 adjustable miter stops. These cut-off saw with an override button that allows the firm set off very close to the stations, without the slide machine gun attack nearby. Bevel angle 0-47 degrees left and right bevel stop of 33.9 degrees are all conveniently controlled from the front of the saw to crawl or climb withoutto adjust to the back of the saw. The GCM12SD also has an ergonomic soft-grip trigger can be positioned vertically or horizontally and diagonally to the right or left, making it easier to use, no matter which hand you prefer.
Power to spare, and other features
There are more than enough power amp 15, 3 HP, 3800 RPM cut virtually everything that is submitted to GCM12SD 12 "(60T) blade standards. BoschSquarelock fence is precision machined to ensure the fence is always aligned at 90 degrees on the table for a very precise cutting and is famous for its environment and does not require one-touch lock / unlock push. The table has integrated Bosch GCM12SD slide out extensions based both on the right and left, leaving up to 40 "material support to the right.
0 comments:
Post a Comment